1989-1995 Toyota Pickup DuroBumps Front Bump Stops 0-3 Inch - No Lift Required [DBF24RPU]

Factory bump stops are basically hockey pucks — rock hard the instant the suspension touches them. DuroBumps DBF24RPU replaces the front bump stops on the 1989–1995 Toyota Pickup with dual-durometer rubber that engages softly and stiffens progressively, killing the shell-shock hit when you bottom out and keeping the truck composed on hard hits.

The DBF24RPU replaces the rear-mounted OEM bump stop on the front driver and passenger sides, fits stock height through 3" of lift with no lift required, and is the only aftermarket bump stop built with the 14° taper needed for even contact on these lower-control-arm-mounted stops. This Pickup-specific kit includes the required nut and bolt for 1989–1995 trucks.

• Dual-durometer rubber — soft initial contact that ramps up progressively, acting like a secondary spring instead of a wall
• Mounts in the OEM location — bolts in with no modifications
• Extends suspension life — absorbs bottom-out loads that would otherwise hammer your shocks and mounts
• Proudly made in the USA
• No loss of up-travel — slightly taller than OEM so it can compress and cushion before the ultimate stop, without limiting wheel travel