Bilstein 5100 Lift Kit (Up to 3") | 2010-2024 4Runner & 2010-2014 FJ Cruiser

Bilstein 5100 struts and shocks paired with American Spring Company (ASC) lift coils. The coils make the lift, so the front 5100 circlip stays on the lowest perch. You keep full up-travel and down-travel, and you get a better ride than a stock coil with added preload.

What's in the box

• (2) Bilstein 5100 adjustable front struts
• (2) Bilstein 5100 rear shocks
• (2) ASC front coil springs (your choice below)
• (2) ASC rear coil springs (your choice below)

Front lift options

• 1.5" lift [ASC 5121]
• 2.5" lift at stock weight, 2" with added weight [ASC 5131]
• 2.5" lift with 200+ lbs added front weight [ASC 3121]

Rear lift options

• 2" lift [ASC 5211]
• 2.5-3" lift, 100-300 lbs added rear weight [ASC 5231]
• 3" lift at stock weight, 2-2.5" with 400 lbs [ASC 5232]
• 2.5-3" lift, 440-880 lbs added rear weight [ASC 5233]

Recommended add-ons

• Strut assembly: front struts arrive assembled and torqued to spec. No spring compressor needed.
• Upper control arms: recommended at 2.5" of front lift and above, to restore alignment and droop travel.
• Front diff drop kit: corrects 4WD CV angles. Not required, but recommended.
• Panhard correction kit: re-centers the rear axle after the lift.

Install time

• Less than 6 hours
• About 7 hours with upper control arms

Please note

• Lift heights are averages. Final ride height depends on your vehicle, its load, and the condition of its suspension.
• Lift heights assume the front circlip is on the lowest perch. Do not raise the perch with lift coils installed. This can damage the strut and voids the manufacturer warranty.
• Kits ship unassembled unless you select assembly. Unassembled kits reuse your stock top hats and stem bushings/washers.
• 4Runner: does not fit 2WD models. FJ Cruiser: 2WD lift heights can differ because the front end is lighter.
• ASC or OME coils are used, depending on availability.