1995-2004 1st Gen Tacoma DuroBumps Front Bump Stops [DBF24R]

Factory bump stops are basically hockey pucks — rock hard the instant the suspension touches them. DuroBumps DBF24R replaces the front bump stops on the 1995–2004 1st Gen Tacoma with dual-durometer rubber that engages softly and stiffens progressively, killing the shell-shock hit when you bottom out and keeping the truck composed on hard hits.

The only aftermarket bump stop built with the 14° taper these trucks need: the stop mounts to the lower control arm and does not meet the strike pad squarely, so without the taper the rubber shears and wears. Fits stock height through 3" of lift with no loss of up-travel.

• Dual-durometer rubber — soft initial contact that ramps up progressively, acting like a secondary spring instead of a wall
• Mounts in the OEM location — bolts in with no modifications
• Extends suspension life — absorbs bottom-out loads that would otherwise hammer your shocks and mounts
• Proudly made in the USA
• No loss of up-travel — slightly taller than OEM, so it cushions before the ultimate stop without limiting wheel travel